Zemax EE Software and Programming Dissertation Example | Topics and Well Written Essays - 2750 words

Zemax EE Softw ar and Programming - Dissertation ExampleAside from investigating properties such as reflection coefficient, assiduity coefficient, temperature variation, and thermal conductivity, additional theoretical estimations are made. An example is the determination of focal length, exposed effective areas, and start out collection and concentration for all components. A number of images are evaluated to examine the effect of different geometric shapes of imperfecting pipes for refraction studies and light cups for reflection studies. Zemax software is used for a large part of this study. Therefore, this chapter inside information the basics of Zemax software for ocular design and radiotherapy tracing. Software programs for lens design and optical studies see been of immense utility in the filong time of optics. Their advent has substantially simplified and enhanced our understanding of optical design and analysis. As stated by Winston, Minano, and Benitez (2005), The design of imaging optical systems is a classic ?eld of research that has achieved a high level of development. There are on the market optical design programs that permit the numerical optimization of the design parameters, allowing us to obtain results that were unattainable with the analytical tools used in the first place the development of computers (p. 219). Software programs are found on a number of optical principles, such as geometrical optics and ray tracing that function according to the basic laws of optics. The following sections discuss these basic principles along with an introduction to Zemax software that is used in this study. 4.2. pecker Tracing Programs and Geometrical Optics The basic tool indispensable in designing any imaging or non-imaging optical system is geometrical optics (Winston, Minano, & Benitez, 2005). Geometrical optics is establish on the universal laws of reflection, refraction, and transmission of light. The incident light on a reflective surf ace and the reflected light from that surface always make equal leans to the normal, and they lie on the same plane. In case of genetical light, the direction of the refracted and transmitted ray changes according to Snells law of refraction, according to which the sine of the angle surrounded by the incident ray and the normal is in constant ratio with the sine of the angle between the refracted ray and the normal, with all three being coplanar (Winston, Minano, & Benitez). Based on these universal laws of light, the expression of a light ray in any optical system chamberpot be predicted. Simple optical systems can be predicted manually, but complex ones require sophisticated computer programs that can easily predict the behavior of light by means of computerized ray tracing. Even the analysis and design of solar concentrators requires such a program. Ray tracing is the process of constructing or following the paths of light rays through an optical system consisting of refrac ting and reflecting surfaces (Winston, Minano, & Benitez, 2005). For instance, the transmission of a specific concentrator can be determined through ray tracing as follows N rays encipher a concentrators aperture at a ? angle of incidence at the entry aperture of the concentrator, as shown in Figure 4.1. Fig. 4.1 Ray tracing of the rays transmitted through a concentrator to determine transmission (Winston, Minano, & Benitez, 2005). After the rays are traced through the optical system, N rays appear from the concentrators exit aperture. The dimensions of the exit aperture are determined based on the required concentration ratio of the system. The remaining N and N rays are lost through various processes such as ray scattering. The transmission power of the system for a different angle of incidence